Publicité
Instruction manual
OPERATING INSTRUCTION
Practical tips
∙
Switch on the equipment.
EN
∙
Work away from the body.
∙
Never move your hands into the direct vicinity of
the work area.
∙
Use only plug-in tools which are in good working
order and undamaged.
Plug-in tools
Sawing
Sawing wood and plastic.
∙
When sawing, watch out for foreign bodies in the
workpiece and remove these if necessary.
∙
Plunge cutting is allowed only in soft materials such
as wood or plasterboard.
Sanding / grinding
Surface sanding/grinding at edges, in corners or hard-
to-reach areas. Depending on choice of sanding/
grinding paper for the sanding/grinding of wood, paint,
lacquer, etc.
∙
This equipment offers particularly high performance
for the sanding/grinding of hard-to-reach corners and
edges.
∙
To sand/grind profiles and channels you can also
work with just the tip or the edge of the sanding/grinding
disk.
∙
Various sanding/grinding papers are available,
specially designed for the different types of material you
may be working on and the amount you wish to remove
from the surface. The amount removed will depend
largely on the choice of sanding/grinding paper and
pressure applied to the sanding/grinding plate.
Scraping
Scraping off old paint or adhesives.
∙
Move the plug-in tool against the area you want to
remove. Begin with a flat angle of incidence and little
pressure. The surface (e.g. wood, plaster) may be
damaged if too much pressure is used.
MAINTENANCE AND STORAGE
Before any work on the device itself,
pull the mains plug.
∙
Always keep the tool and the ventilation slots (if
present) cleaned. Regular cleaning and maintenance of
the appliance will ensure efficiency and prolong the life
of your tool.
∙
If the tool should fail despite the rigorous
All manuals and user guides at all-guides.com
manufacturing and testing procedures, the repair should
be carried out by an authorized IVT customer service.
∙
Keep all nuts, bolts, and screws tight, to be sure the
tool is in safe working condition.
∙
Replace worn or damaged parts for safety.
∙
Use only original spare parts. Parts not produced
by manufacturer may cause poor fit and possible injury.
∙
Store the tool in a dry room out of reach of kids and
away from any flammable material.
∙
Never wet the device or spray water on it!
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of
disposing as waste.
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labeled for categorized
recycling. These instructions are printed on recycled
paper manufactured without chlorine.
10
Publicité
