Publicité
Les langues disponibles
Les langues disponibles
Remote Control (*) option
Installing and Replacing Remote Control Batteries
As it can be seen in Figure 1 below, the tabs are pushed in the direction shown by the arrow, it
is simultaneously pulled in the direction shown by the arrow in the second figure and the battery
is replaced. A new battery is installed using the same method. Only Cr2025 batteries must be
used
.
The button used for turning on and off the product.
Used to decrease the level, heat and timing values.
Used to increase the level, heat and timing values.
Heating level adjustment: shifts to power control mode.
make level adjustment between levels 0 and 4. The alarm gives a signal for 0.2 seconds
in every step and L1, L2, L3, L4, L0 appear.
Thermostat button: shifts to heat adjustment mode.
make heat adjustment between 10 and 40 degrees. The thermostat button must be
pressed to save the adjusted heat. It is enough to press this button once for the user to
see the adjusted heat. The alarm gives a signal for 0.3 seconds in every step.
Timer button: It shifts to the timing mode by flashing on the screen and timing up to 9
hours is carried out with
pressed again to save. It is enough to press this button once for the user to see how much time
is left. 0H, 1H,....9H appear on the screen.
Note: the point on the right of the screen flashes when the timer of the product is ready.
1L, 2L... : show the power level of the heater.
1H, 2H, 3H,...9H : heater timer indicator (programming up to 9 hours is possible) Er: error
indicator; it indicates that the device is not balanced.
OH: Overheating: when the device detects heat from the environment other than its heat
program, it rings an alarm for 1 minute as a warning and stops the heating function.
Without Remote Control
Function Button:
The heat level is increased one level with each pressing.
This button is pressed for 6 seconds to perform timer adjustment. The desired time zone is
selected from the emerging screen menu.
Product Stand By :
10
All manuals and user guides at all-guides.com
and
It controls the heat level adjustment and timer adjustment of the heater.
this symbol appears on the screen, it is ready for operation.
and
buttons. After the timing is done, the timer button is
1
2
and
buttons are used to
buttons are used to
Publicité
