Aerus BEYOND SANCTUAIRY Manuel De L'utilisateur page 14

R E P L A C I N G T H E B A L L A S T
CAUTION: Disconnect power at the breaker or fuse panel before servicing unit. Always
follow OSHA lockout procedures to prevent accidental exposure to electrical energy.
1
1. Disconnect (unplug) power cord from unit.
Always follow OHSA electrical lockout safety requirements
to prevent Accidental release of energy during service or
maintenance activities.
3
3. Disconnect all ballast wiring by pressing down on
connector tabs and pulling wire straight out.
5
5. Place new ballast into original location
and secure using the
two (2) nuts removed in step 4.
14
All manuals and user guides at all-guides.com
WARNING! - UV Light in operation. Disconnect unit from power cord before
servicing. Failure to follow warnings may result in severe eye damage.
Power
Cord
2
2. Open the ballast housing by
removing the four (4) screws then
removing the cover.
4
4. Remove the two (2) nuts
securing ballast to the case.
Remove the ballast.