Philips HF8410 Mode D'emploi page 8

EnglisH
8
Pre-warming the massager
The charger has a pre-warming button that you can use to pre-warm the bottom of the massager
to a comfortable temperature (approx. 40°C).
Never warm the massager in an oven or microwave.
1 Place the massager on the charger. It only fits properly on the charger with the buttons facing
up.
2 Press the pre-warming button (Fig. 3).
, The pre-warming light ring starts flashing to indicate that the massager is warming up.
, After approx. 5 minutes, the pre-warming light ring stops flashing and lights up continuously
to indicate that the massager has reached a comfortable temperature.
, After 30 minutes, the pre-warming function automatically switches off, but you can also
switch it off by pressing the pre-warming button again.
using the appliance
1 Press any button to switch on the massager (Fig. 4).
, The light ring goes on.
, The massager starts operating in the default mode (mode 1) and at moderate vibration
speed.
Tip: We advise you to start in the default mode. You can gradually increase the vibration speed once you
are familiar with the options.
Note: If you feel uncomfortable during use, you can adjust the vibration speed. See step 3.
2 Press the mode selection button to adjust the vibration to your own preference (Fig. 5).
- The appliance has 5 vibration modes (A to E) that activate up to 3 vibrations spots placed in
the tip (1), the top (2) and the bottom (3) of the massager (Fig. 6).
a
Tip motor runs, vibration is focused on one point
B Tip and bottom motors run in turn
c
Top and bottom motors run in turn
D Tip and top motors run in turn
E All motors run in turn
3 Press the increase or decrease button one or more times to adjust the vibration speed of
the massager to your own preference. (Fig. 7)
The appliance has 5 speed levels.
4 You can hold the massager in different ways. Experiment to find the most comfortable way to
use the massager.
Tip: For suggestions, consult the welcome booklet.
Tip: You can also use the massager in combination with a water-based or silicone-based lubricant or
massage oil. Do not use scented and/or alcohol-based lubricants or massage oils, as they may cause
damage.
5 To switch off the massager, press and hold the mode selection button or the decrease button.
travel lock
It is possible to lock the massager, for example if you are going to travel. The travel lock prevents the
massager from being switched on by accident.
1 Switch off the massager.
All manuals and user guides at all-guides.com