Glare Protection Ring; Diffusers - Adam Hall CAMEO Q-SPOT 40i Manuel D'utilisation

/ BRIGHTNESS
Set the brightness in 12 steps Press the button and select the desired brightness by using the + and - buttons (level 1 = blackout).
FL / FLASH (strobe)
Activate the strobe effect and set one of its 14 speeds After pressing the FL button, the static mode will be automatically activated (color
mixing with the R, G, B, A buttons). Use the + and - buttons to select the flash frequency (level 1 = strobe deactivated, level 2 = slowest
flash frequency, level 14 = fastest flash frequency).
R / G / B / A (W, UV, CW, and WW have no function)
An individual color mixture can be set using the 4 buttons R, G, B, A (static mode – static). The 12 brightness levels can be called up by
pressing the respective color button, then using the + and - buttons, where level 1 means that the LEDs are switched off.
Example: If you set red and green at their respective maximum levels, and blue and amber at their lowest (off), then you will have a color
mix of light yellow.
PG (Auto Jump / Auto Fade)
Press the PG button and select the operating modes "Auto Jump" or "Auto Fade" by using the + and - buttons. Set the program run-speed
by pressing SP (Speed) and using the + and - buttons.
CM (color macros)
15 color presets can be retrieved by pressing CM and using the + and - buttons.
SC (no function)
AU (auto program)
Automatic switch between "Auto Jump" and "Auto Fade" The speed is set with the buttons SP and + and -.

GLARE PROTECTION RING

The spotlight has an adjustable glare protection ring. Turn the ring to the desired position.

DIFFUSERS

Included with the spotlight are two diffusers, which have differing dispersion characteristics (10°, 25°). The beam angle of the spotlight
can therefore be individually set to 4.5° (without diffuser), 10° or 25°. Place the desired diffuser on the lighting lens in the same way as a
bayonet fastening, then turn it anti-clockwise until the magnets in the diffuser (A) and the two opposite magnets, which are embedded in
the glare protection ring (B), are directly on top of one another (C) and the diffuser is securely held in place. When doing so, ensure that the
side of the diffuser in which the 2 magnets are integrated is facing toward the spotlight.
10