Publicité
Les langues disponibles
Les langues disponibles
Replacing the light bulb
If the internal light does not work anymore, disconnect
then reconnect at once the device. If the light does not
still work, verify if the light bulb is correctly screwed. If
in spite of these tests, there is no light, it is necessary
to change the light bulb. Use a 220-240V~, MAX 10W
light bulb.Proceed the following to replace a failure
bulb.
Switch off at the socket outlet and pull out the
l
mains plug;
Remove the light diffuser cover by pulling the
l
recess at the edge;
Replace the screw cap bulb;
l
Assemble the light diffuser cover and switch
l
on.
DOOR REVERSE
Users can change the direction of opening according
to one's own needs. The concrete operating sequence
is as follows:
-37-
Publicité
