Uline IH-8306 Instructions De Montage page 3

NOTE: Use a screw gun with an adjustable
clutch, and take care not to over tighten and
strip the threads. DO NOT USE IMPACT TYPE GUNS.
NOTE: Holes are not pre-drilled. Apply pressure
with self-tapping screws to puncture post.
6. Mount door stopper to opposite / receiving post
using remaining self-tapping screw. (See Figure 8)
Figure 8
7. Attach handle to door using the provided handle
and bolts. (See Figure 9)
Figure 9
PAGE 3 OF 9
INSTALLATION CONTINUED
MOUNTING THE POSTS
8. Verify that the first post is positioned in the desired
9. Using a 3/8" masonry drill bit, drill a hole approximately
Door
Stopper
10. Clean out debris and dust from inside the hole, and
11. Tap down the anchor bolt with a hammer. Slide
1-800-295-5510
uline.com
location. Mark the floor where the holes will be drilled.
3" deep into the floor. (See Figure 10)
Figure 10
Anchor Bolt
3/8"
Masonry
Bit
fully insert anchor bolt through the mounting plate
and into the hole.
washer onto anchor bolt. Using a 17 mm wrench,
tighten the hex nut until the anchor bolt is secure.
Repeat for remaining anchor.
0823 IH-8306