ATTACHING PANELS TO POSTS
NOTE: Safe installation requires two people.
NOTE: When assembling, ensure panels and
posts are aligned at the top.
1.
To assemble a straight run, end to end, use straight
bolts and flat washers. (See Figure 1)
Figure 1
Straight Bolt
Bolt Head
Flat Washer
2. To assemble a 90° corner, use curved bolts and lock
washers. (See Figure 2)
Figure 2
Curved Bolt
Lock
Washer
3. Use a 13 mm wrench to tighten.
4. Repeat steps 1-3 until all posts and panels have
been attached. The number of posts and panels will
vary depending on room size.
ATTACHING SLIDING DOOR TO POSTS
1.
Using straight bolts, washers and nuts, install upper
door track onto posts. Door track installs on top hole
of post. (See Figure 3)
Figure 3
Post
PAGE 2 OF 9
INSTALLATION CONTINUED
Flange Nut
Panel
Flange Nut
Bolt Head
Upper Door Track
2. Insert and attach trolley assembly to top of door.
(See Figure 4)
Figure 4
3. Slide the assembled door into the upper door track.
(See Figure 5)
Figure 5
Trolley Assembly
Door
4. Mount floor door track using concrete anchors.
(See Figure 6)
Figure 6
5. Attach latch receiver and bottom door slam using
four self-tapping screws. (See Figure 7)
Latch
Receiver
Bottom
Door Slam
Figure 7
0823 IH-8306