Avocent DSR Mode D'emploi page 33

All manuals and user guides at all-guides.com
-or-
To add a target device within an existing list, place your cursor in the line below where you
want to insert a new target device and press
4. Type the first few characters of a target device name or port number to scan. The first matching
target device will appear in the line.
-or-
Press the following keyboard commands in the Name, Port or Time column to move through
the list of target devices available to scan.
a. Press Alt+Down Arrow
b. Press
Alt+Up Arrow
c. Press
Alt+Home
d. Press Alt+End to move the cursor to the last target device in the list.
5. In the Time column, type the number of seconds (from 3-255) of desired time before the scan
moves to the next target device in the sequence.
6. Move the cursor to the next line or press
remaining target devices to be included in the scan pattern.
7. Click OK to save your settings.
To remove a target device from the Scan list:
1. In the Scan dialog box, click the target device to be removed.
2. Press Delete .
-or-
Press to remove the selected target device and all entries below it.
Shift+Delete
3. Click OK to save your settings.
To start the Scan mode:
1. If the OSCAR interface is not open, press
2. Click Commands to open the Commands dialog box shown in Figure 3.3.
Insert
to move the cursor down through the list of target devices.
to move the cursor up through the list of target devices.
to move the cursor to the first target device in the list.
Down Arrow
Print Screen
Chapter 3: Local Port Operation
.
and repeat steps 2-5 for each of the
to open the Main dialog box.
21