Domo DO1950S Mode D'emploi page 11

DO1950S
IMPORTANT MEASURES OF SAFETY
The appliance is designed solely for domestic and not for professional use.
Do not use the appliance for any other purpose.
Do not use the appliance outdoors.
Avoid electric shocks and do not expose the appliance to water or other liquids.
The safety button avoids an unintentional start of the slicing machine. When you have
fi nished cutting, always set the safety button to "0".
Withdraw the electric plug before removing parts and cleaning the appliance.
Do not use the appliance for longer than ten minutes at any one time. Allow it to cool
before continuing to work.
Do not use the appliance for cutting frozen food or bones.
Do not use the appliance, unless the blade is well in place.
Handle the blade with the greatest possible care when you are removing it, cleaning it,
or replacing it in the machine.
Do not touch the cutting edge of the blade.
Note that the blade continues to revolve for a moment after the appliance has been
turned off.
To avoid any danger of injury, the food must always be cut using the food board and
pressure plate. Always use the food board and pressure plate, unless the size and shape
of the piece to be cut do not allow it.
After using and before cleaning the appliance, always set the cut thickness adjustment
and the safety button to "0".
Do not use this appliance, if the plug or the electric cable have become damaged, if
it functions badly, if it has fallen on the fl oor, or after it has been immersed in water.
Take the appliance to your retailer for checking and repair.
Do not place the electric cable on the edge of the table or on a hot surface.
If the electric cable has become damaged, it must be replaced by an approved repairer
possessing the required tooling.
Do not use any accessories, which were not supplied with the appliance.
Don't let the appliance be used by children.
Exercise care, if the appliance is being used by invalids or close to invalids.
CAREFULLY KEEP THESE INSTRUCTIONS SAFE
INSTRUCTIONS FOR USE
Place the slicing machine on a fl at, stable support, in order to prevent it from sliding.
Take care that the safety button is set at "0" before introducing the plug into the
electric socket.
Use an alternating current plug, which is suitable for the voltage shown on the
appliance (230 V 50 Hz 100 W).
Before starting the appliance, set the safety button at "1" and press the contact button.
Press the safety button towards the "1" again to turn the appliance off. Be very careful
during the process of cutting. Release the contact button to stop the appliance.
11