GOEBEL GO - BR1 Mode D'emploi page 29

4. Tool operation (important tips before starting work)
• Please charge the battery to 100% before first use (according to the relevant government regulations)
• The function settings must be determined in advance according to the rivet specifications, sheet thickness and riveting
conditions (see page 10).
Very important, if the rivet mandrel container is more than two thirds full, it must be emptied in time,
otherwise the normal use of the tool may be impaired or the riveting tool may be destroyed! Note that after
determining the stroke, start riveting according to the set mode, riveting operation procedure as shown in the
following figure:
4.1 Riveting in conventional mode (D)
➀ Insert rivet into workpiece, pay attention to the vertical! ➁ Load nose piece into rivet
mandrel, pay attention to the vertical! ➂ Pull the trigger and start riveting ➃ After
riveting, the tool tilts back to let the broken residual mandrel fall into the collecting
container ➄. If the residual rivet mandrels in the collecting container are more than 2/3,
unscrew the collecting container, remove the residual rivet mandrels and screw the
collecting container back on.
4.2 Riveting in self-locking mode (S)
① Load the rivet into the nosepiece. ② Pull the trigger and lock the rivet mandrel.
③ Make sure the mandrel is locked and ready to rivet. ④ The rivets are inserted into the
workpiece and you pull the trigger again, pay attention to the vertical! ⑤ After riveting,
the tool is kicked backwards and the residual mandrel flies into the collecting container.
⑥ If there are more than 2/3 of the mandrels left in the container, unscrew the container,
remove the mandrels and screw the container back on.
www.goebel-group.com
English | 12 Deutsch | 2