Connecting Antennas; Using External Antennas; To Improve Am Reception - Pioneer VSX-518 Mode D'emploi

03 Connecting up

Connecting antennas

Connect the AM loop antenna and the FM wire
antenna as shown below. To improve reception
and sound quality, connect external antennas
(see Using external antennas below).
fig. a
5
1 Pull off the protective shields of both AM
antenna wires.
2 Push open the tabs, then insert one wire
fully into each terminal, then release the tabs
to secure the AM antenna wires.
3 Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. a) then
clip the loop onto the stand (fig. b).
• If you plan to mount the AM antenna to a
wall or other surface, secure the stand with
screws (fig. c) before clipping the loop to the
stand. Make sure the reception is clear.
4 Place the AM antenna on a flat surface
and in a direction giving the best reception.
5 Connect the FM wire antenna in the same
way as the AM loop antenna.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don't drape
loosely or leave coiled up.
14
En
fig. b fig. c
3
FM UNBAL
75
Ω
AM
LOOP
4
1
2

Using external antennas

To improve FM reception
Use an F connector to connect an external FM
antenna.
F connector

To improve AM reception

Connect a 5 m to 6 m (15 ft. to 18 ft.) length of
vinyl-coated wire to the AM antenna terminal
without disconnecting the supplied AM loop
antenna.
For the best possible reception, suspend
horizontally outdoors.
Outdoor
antenna
FM UNBAL
75
Ω
AM
LOOP
5 m to 6 m
(15 ft. to 18 ft.)
FM UNBAL
75
Ω
AM
LOOP
Indoor antenna
(vinyl-coated wire)