Publicité
Les langues disponibles
Les langues disponibles
OH 0335
1T LOW PROFILE FOLDABLE CRANE
• This shop crane is designed for lifting purposes only.
• Not designed for supporting loads.
• Do not load beyond it's rated capacity.
• Do not overload. Overloading could cause damage or failure of the engine crane.
• Never use the crane on an uneven fl oor surface as this could result in the crane tipping over.
• Always lock the legs and jib in position before lifting a load.
• The nuts and bolts supplied with the crane are all high strength and should not be subsituted for
inferior types.
• Before each use ensure that all nuts and bolts are correctly fi tted and tight.
• Do not lift people
• Never exceed the safe working loads indicated on the jib.
CARACTERISTIQUES
- double acting pump
- 360° rotating pump
- deadman lowering control
- 3 positions arm: 1000-750-500kg
- low profi le: 85mm
- nylon wheels
- standards: 2006/42/EC, EN ISO 12100:2010 and EN 1494:2000+A1:2008
UTILISATION
To raise load
Close release valve by turning handle clockwise to a snug-tight position (Do not overtighten).
To lower load
Open release valve by turning handle counterclockwise very slowly. The speed of lowering the
load is controlled by how much you turn the handle.
Note :
Front legs must always be locked in down position before applying load and/or raising boom.
Boom must be in fully lowered position before raising legs. Legs must never be raised when crane
is carrying load. Legs must be locked in place when raise.
It is possible that air has got into the hydraulic system, causing poor lifting performance. Purge
any air from the system by fully opening release valve (turn handle counterclockwise), then while
holding the boom down, operate pump handle rapidly several times.
Failure to follow these instructions could result in loss of load and/or personal injury or damage
to property.
All manuals and user guides at all-guides.com
WARNING
Publicité
