Epson TM-T88V Manuel De L'utilisateur page 5

DIP Switch Tables
DIP switch 1 (Serial Interface)
SW Function
1-1 Data receive error
1-2 Receive buffer
capacity
1-3 Handshaking
1-4 Data word length
1-5 Parity check
1-6 Parity selection
1-7 Transmission speed (See table A.)
1-8
Table A
Transmission speed (bps)-bits per second SW1-7 SW1-8
*1
38400
4800
9600
19200
DIP switch 1 (Parallel/USB Interface)
SW Function
1-1 Auto line feed
1-2 Receive buffer
capacity
*2
1-3 Select paper sensors
to output paper-end
signals (default value
of a command) from
parallel I/F.
*2
1-4 Error signal output
from parallel I/F
1-5~ Undefined
1-7
*3
1-8 Power saving function
for USB
*1: When DIP Switches 1-7 and 1-8 are on, the transmission
speed can be selected from one of seven speeds:
2400, 4800, 9600, 19200, 38400, 57600, and 115200 bps
by control commands.
*2: For USB I/F, DIP Switches 1-3 and 1-4 are Undefined.
*3: For Parallel I/F, DIP Switch 1-8 is Undefined.
Specifications
Printing method
Dot density
Printing direction
Printing width
Characters per line
(default)
All manuals and user guides at all-guides.com
ON OFF
Ignored Prints "?"
45 bytes 4K bytes
XON/XOFF DTR/DSR
7 bits 8 bits
Enabled Disabled
Even Odd
ON ON
OFF ON
ON OFF
OFF OFF
ON OFF
Always Always disabled
enabled
45 bytes 4K bytes
Disabled Roll Paper end
sensor enabled,
Roll Paper near-
end sensor
enabled
Disabled Enabled
Disabled Enabled
80 mm paper width
Thermal line printing
180 dpi ×180 dpi [dots per 25.4 mm {1"}]
Unidirectional with friction feed
72 mm {2.83"}, 512 dot positions
Font A: 42; Font B: 56
DIP switch 2-1~ 2-6
SW Function
2-1 Handshaking Receive buffer
(BUSY condition) full
2-2 Do not change
settings
2-3 Print density
2-4
2-5 Release condition of Releases BUSY
receive buffer BUSY when remaining
(If receive buffer receive buffer
capacity set to 4 KB.) capacity
reaches
138 bytes.
2-6 Do not change
settings.
DIP switch 2-7, 2-8 (Serial Interface)
SW Function
2-7 I/F pin 6 reset Enabled
2-8 I/F pin 25 reset Enabled
DIP switch 2-7, 2-8 (Parallel/USB Interface)
SW Function
2-7 Do not change
2-8 Do not change
Table B
Print density/low power
Print density "Normal"
Print density "Medium"
Print density "Dark"
Do not set
58 mm paper width*
50.8 mm {2.0"}, 360 dot positions
Font A: 30; Font B: 40
English
ON OFF
Offline or
Receive buffer
full
Fixed to OFF
See Table B
Releases BUSY
when remaining
receive buffer
capacity
reaches
256 bytes.
Fixed to OFF
ON OFF
Disabled
Disabled
ON OFF
Fixed to OFF
Fixed to ON
SW2-3 SW2-4
OFF OFF
ON OFF
OFF ON
ON ON
v