Publicité
Les langues disponibles
Les langues disponibles
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
INSTALLATION
For easy installation, select an existing light operated
by a wall switch for replacement.
For best performance, mount the fixture about 8 feet
(2.4 m) above the ground. NOTE: If fixture is mounted
higher than 8 ft. (2.4 m), aiming the sensors down will
reduce coverage distance.
Wall Mount
Get user manuals:
See SafeManuals.com
Move ON-TIME Switch
to 1, 5, or 10 minutes
Flip light switch
off for one second
then back on*
Eave Mount
For under eave installation, the sensor heads must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
For eave mount only:
❒ Swing the sensor heads toward the clamp screw
joint.
Clamp Screw
Controls
❒ Then rotate the sensor heads clockwise 180° so
the controls face down.
Controls
If a sensor pops out of the ball joint, loosen the clamp
screw and push the sensor back into the ball joint.
Tighten the clamp screw when done.
For second story installation, point one sensor head for-
ward for maximum coverage and point the other sensor
head downward for coverage close to the building.
Also, one sensor may be pointed toward a specific
area for coverage while the other is pointed forward for
maximum coverage.
2
Controls
Controls
598-1351-01
Publicité
