Pentamark MSL360FWPB Mode D'emploi

Motion Sensor
Light Control
Model MSL360FWPB
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
This package includes:
Lamp Holders
Cover
Plate
Mounting Bolt
6 Screws
(3 sizes included)
Pentamark LLC
Get user manuals: See SafeManuals.com
Meets the ENERGY STAR
when used with 120 W Max bulbs.
Features
Plastic Hanger
Sensors
Light Control
Mounting Strap
2 Shells
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
guidelines
®
Mode:
Test
Normal
Manual
Note: When first turned on wait about 1
the circuitry to calibrate.
Put the ON-TIME switch on the
bottom of the sensors in the TEST
position.
Rubber Plug
Put the ON-TIME switch in the
1, 5, or 10 minute position.
3 Wire
Manual mode only works at night
Connectors
because daylight returns the sen-
sors to AUTO.
Flip the light switch off for one sec-
ond then back on to toggle between
AUTO and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 10
position.
Gasket
Requirements
OPERATION
On-Time: Works:
5 Seconds
1, 5, 10 min.
Until Dawn*
* resets to Auto Mode at dawn.
TEST
AUTO
MANUAL MODE
Day Night
x x
x
x
/ minutes for
1
2
ON-TIME
10 5 1 TEST
ON-TIME
10 5 1 TEST
1 Second OFF
then...
... back on.
598-1351-01