Publicité
Les langues disponibles
Les langues disponibles
CHANGING DOOR OPENING SIDE
You can change the door opening side of your device by moving the hinges. When remounting, make
sure that the door is properly aligned with the body and that the seal closes properly.
Please do not forget that changing the door opening side must be done while the appliance is
unplugged.
① Lockup screw
② Lower door hinge
③ Door pivot assembly
④ Right upper door hinge
Note: unused components should be preserved for future use.
1. Open the glass door and fasten two lockup screws ①, and support the door pivot towards
the glass door. After taking out the screws, be careful to support the glass door. (as shown
in Figure 1)
2. Pull the glass down downwards and remove it, and place the glass door onto the soft gasket
to prevent any scratch to the glass surface.
3. Remove 3 screws from the right side of the door bottom, and 3 screws from the right side of
the door top. (as shown in Figure 2)
4. Remove the hinge for the right upper door ④. Take out the hinge for the left upper door
hinge ⑥ from the plastic bag of installation instructions, and install it at the left specific
position. Then, accordingly mount the upper door shaft assembly. (as shown in Figure 3)
5. Remove the door pivot ③ from the right lower hinge ③, and then insert it in the door pivot
at the left lower part of the door front.
6. Turn the glass door at 180°, and then mount it back at its specific location, and lock up the
screw ① using two screws to connect the door pivot ③ assembly and the glass door, and
fasten the screws before door leveling.
Imported by SIDEME SA – BP200 – F92306 Levallois Perret cedex
⑤ Lower door hinge (the same for the left
and right)
⑥ Left upper door hinge
30
Publicité
