RC Factory S-IDEE 144010 Manuel De L'utilisateur page 20

*Never run the model on public roads or streets,as it could interfere with traffic.
*To preventy property damage and/or personal injury. Never run the model in crowded areas,
near or toward people or animals,
*Never run the model near rivers,ponds or lakes.
*Make sure that no one else is using the same frequency
in your running area. Using the same frequency at the same time,
can cause loss of control with R/C model,resulting in serious accidents.
*To avoid a runaway R/C model or loss of control always follow the
procedure below;
1.
Fully extend transmitter antenna.
2.
Switch the transmitter on.
3.
Switch on the R/C model.
*Follow reverse procedure to shut down.
*Never touch or block rotating tire.
*Never run R/C model in the rain or in puddles,as water may
cause trouble with R/C model.
*Motor and battery get very hot after running.Take care when handle them.
*Retract tranmitter antenna when not in use.
*Remove the batteries from model and transmitter when they are not in use.
Do not dismantle the battery or charger and do not cut and battery cables.
*
Altering the bttery may cause short-circuit and/or damage to the product.
*Charge battery with compatible charger following proper procedure outlined
in the instructions. Do not modify charger or charge battery in improper way.
*Do not recharge battery if it is still warm from use at is may damage the battery.
Allow the battery to cool off prior to recharging.
*Make sure to disconnect charger from R/C model and electrical outlet
when not in use.
*Remove transmitter battery when not using it for a long period of time as it may
leak and damage transmitter.
*Never incinerate used batteries,as they can explode causing serious accidents.
Do not operate the model on
public roads,in crowded places
or near infants,it may cause
accidents or injury.
The front end of the antenna
may be dangerous,do not aim
it toward faces.
The product includes small and
sharp parts,assemble and store this
product only in places
out of the reach
of children.
During and after operation,the motor
will be hot.
Please do not touch it until it has
had time to cool down.
EN