Publicité
Les langues disponibles
Les langues disponibles
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental capa-
bilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
without supervision.
• Do not immerse the device into water for cleaning. Please follow the
instructions as stipulated in the chapter "Cleaning".
Overview of the components
1 Hook
2 Propeller
3 Motor shaft
4 Motor
5 Adjustment knob for oscillation
6 Switch housing
7 Stand/gear casing connection screw
8 Nut for height adjustment
9 Cover cap
10 Stand tube
11 Screws and washers for mounting the foot
12 Mounting plate
13 Base
14 Operating mode switch
15 Rear protection grid
16 Fastening nut
17 Attachment ring for rear protection grid
18 Fastening screw
19 Fastening screw
20 Front protection grid
Unpacking the Device
1. Remove the device from its packaging.
2. Remove all of the packaging material such as foils, filling
material, cable holders and cardboard packaging.
3. Check the scope of delivery.
4. Check the appliance for any transport damage to prevent a
hazard.
NOTE:
There may still be dust or production residues on the surface
of the device. We recommend that you quickly wipe off the
housing with a damp cloth.
26
Assembly instructions
The device must be completely assembled before initial opera-
tion!
NOTE:
•
You will need a Phillips screwdriver of medium size for
the assembly.
•
Screws not included as accessory are already pre-
installed at the respective parts.
•
Also observe the "Overview of the Components" on
page 3.
1. Place the parts of the base together in the shape of a
cross.
2. Screw the mounting plate (12) tightly to the base. For this
you should use the four crosshead screws and washers
supplied.
3. If necessary, remove the height adjustment nut (8). Push
the covering cap (9) on to the lowest position of the upright
tube (10). Screw the height adjustment nut back on to the
upright tube (10).
4. Loosen the connection screw (7) and insert the gear cas-
ing (6) and the motor casing (4) on the stand tube. Then
tighten the connecting bolt by hand.
5. Unscrew the mounting ring (17) in an anticlockwise direc-
tion. Keep it ready to hand.
6. Position the rear protection grid (15) in place in accordance
with the recesses.
NOTE:
Please ensure that the carrying handle is facing upwards.
7. Turn the attachment ring (17) for the rear protection grid (15)
slightly in a clockwise direction.
8. Attach the propeller. Note the position of the guide pin on
the motor shaft.
Publicité
