JUNO J6SLC RGBW MW Instructions D'installation page 8

TROUBLESHOOTING GUIDE:
Problem:
Fixture will not illuminate
Circuit breaker trips when
fixture is illuminated
Light flickering
Speaker sound cuts in and out
Two or more "MASTER" units
are created during speaker
grouping set-up (Two or more
fixtures show blue light after
speaker pairing)
Any fixtures show "red" light
after group creation
Add additional speakers to
already existing speaker
group
Factory Reset Fixture
If further assistance is required, contact Technical Support at: (800) 748-5070
INSTALLATION INSTRUCTIONS
Corrective Action:
1. Verify line voltage is correct.
2. Check wiring and connections
3. Verify power supply is on at breaker
Check wire connections. Ensure wires are not crossed and power wire is not grounding out.
Consult electrician.
1. Verify line voltage is correct
2. Check wiring and connections
3. Consult electrician
4. Install a light switch on the wall. Dimmers are not allowed
1. Confirm your device is within 30 ft of the "MASTER" unit and any paired "SATELLITE"
units are within 30 ft of the "MASTER" unit. Obstructions between the speaker and the
Bluetooth® enabled device may cause signal interference
2. To prevent signal interference, do not place the speaker downlights close to heavy
electromagnetic emission devices or equipment such as household appliances or ceiling
fans
1. Set desired master to any RGB color via app
2. Set second or more blue lights to "off" via app
3. Turn all lights off form Wall Switch. Wait ten seconds and turn them back on.
Note: Do these steps within one minute
1. Set desired master to any RGB color via app
2. Set "red" lights to "off" via app
3. Turn all lights off from wall switch. Wait ten seconds and turn them back on.
Note: Do these steps within one minute
1. Set the master to any RGB color via app
2. Set the new lights to "off" via app
3. Turn all lights off from wall switch. Wait ten seconds and turn them back on.
Note: Do these steps within one minute
To factory reset the fixture, use the wall switch to cycle power "on" and "off" five times. Then,
repeat the installation process from the beginning.
Note: Wait five seconds between turning the fixture "on" and "off". Complete all power cycles
within one minute.
One Lithonia Way · Conyers, GA 30012 · Phone 1-(800)705-7378
Visit us at www.acuitybrands.com/juno-recessed
© 2023 Acuity Brands Lighting, Inc
Juno Smart LED RGBW Speaker LED Trim Kit
.
912-00386-001 REV B
DATE 05/2023
8
PAGE |