JUNO J6SLC RGBW MW Instructions D'installation page 7

Step 5: SET UP SPEAKER GROUPING
Note: Every fixture installed can be set as a "MASTER" unit or "SATELLITE" unit. For each speaker group, only one fixture can
be the "MASTER" unit, and the rest will be "SATELLITE" units.
Note: Step 5 is only required if multiple units will be paired together for audio control. If the user would like to play audio from a
singular fixture, this section can be skipped.
5.1 Determine which fixture in the speaker group is optimal to be selected as the "MASTER" unit. The
remaining units in the speaker group will be "SATELLITE" units.
Note: The fixture selected to be the "MASTER" should be the unit most centrally located in perspective to all other fixtures in the
desired speaker group. The "MASTER" unit is the fixture that connects to the smart device for casting audio and controls the rest
of the speaker group.
Note: If a "SATELLITE" unit is over 30 ft away from the "MASTER" unit, audio may sound distorted.
Note: If the smart device for audio control is over 30 ft from the "MASTER" unit, the entire speaker group's audio may sound
distorted.
5.2 To set-up "MASTER" and "SATELLITE" units, navigate to the device interface in the smart app
(Google Home, Alexa app, or SmartThings). Set the "MASTER" unit to "On" via app and set the
remaining "SATELLITE" units light to "Off" via app. (Figure 7)
Note: The wall switch sending power to the fixtures in the room must remain "ON" during step 5.2 of the speaker group creation.
Toggling the fixtures "On" or "Off" must be done through the smart app controlling the fixtures.
5.3 Once step 5.2 is completed, perform a power cycle to the fixtures in the speaker group. This is done
by toggling the wall switch powering the fixtures in the room "Off" for 10 seconds and then back "On",
again.
Note: Wall dimmer switches are not compatible with the speaker light. Do not use a wall dimmer switch to control the power
cycling of the fixture. Dimming is controlled through the smart app.
5.4 If the speaker group set-up was completed successfully, the "MASTER" unit's light output will show a
blue light, and the "SATELLITE" units will show a green light. Any unit not paired successfully will
show a red light. If there is more than one blue fixture or if any fixtures have red light, refer to the
troubleshooting guide below.
5.5 Once the speaker group has been set up correctly, audio can now be played throughout the newly
created speaker group. Navigate to the smart device's Bluetooth settings and connect to the device
named "Juno Speaker" for audio control.
Note: Only the smart device (Smart Phone, Tablet, etc.) is required for volume and audio control of the speaker. SmartThings
hub, Amazon Alexa, and Google Home control the lighting. Ensure the "Juno Speaker" device is selected for the streaming
service the smart device plays audio through.
INSTALLATION INSTRUCTIONS
Figure 7
One Lithonia Way · Conyers, GA 30012 · Phone 1-(800)705-7378
Visit us at www.acuitybrands.com/juno-recessed
© 2023 Acuity Brands Lighting, Inc
Juno Smart LED RGBW Speaker LED Trim Kit
.
912-00386-001 REV B
DATE 05/2023
7
PAGE |