In the front of the fan, there is a small box below the vent .There is a sponge inside the
fragrance box. Take out the box and put some fragrance on the sponge if you would like
the wind blow with fragrance.
CAUTION
1. Use as per the rating voltage.
2. Do not repair or remake the appliance by yourself, it should be repaired by the
repairmen.
3. Do not operate the appliance with wet hands, in order to avoid damage.
4. If the supply cord is damaged, it must be replaced by a same cord from the
manufacturer or its service agents.
5. When the appliance is not in use, switch it off and unplug it.
6. Do not insert things to air outlets and inlets, in order to avoid damage.
7. Do not use the appliance near explosive and combustible gas.
8. Use the appliance only on a flat surface.
9. Do not use outdoors.
10. .Do no turnover the appliance. Unplug the power supply If it is toppled over and there
have some water in the body. Dry the body before use.
13.Clean the appearance with a lightly damp cloth.It can clean with
neutral
detergents. Do
not rinse with water.
14.Do not make air outlets and inlets near the wall or curtain.
15.Do not knock or shake the body when use, otherwise it may cause stop.
17.The appliance must not located immediately below a socket outlet.
The rating current of socket should exceed 10A.
18.Do not use the appliance in the immediate surrounding of a bath,a show
or a swimming pool.
19.This appliance is not intended for use by persons including children with reduced
physical, sensory or mental capabilities or lack of experience and knowledge unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
20.Children should be supervised to ensure that they do not play with the appliance.
CLEANING AND MAINTENANCE
Clean with neutral detergent and soft cloth.
Attention: unplug the power plug when clean the appliance ,since there have high
pressure in the body. Do not leave any water on the control panel.
ACCESSORY
Screws for assemble the base ; Remote control