Publicité
Les langues disponibles
Les langues disponibles
EN
Network connections
It is possible to connect the camera to a WiFi network via a mobile phone through the app. V-stream.
The device can support a limited number of "unicast" connections so it is possible to show the video
on maximum 3 remote devices at the same time depending on the available network band.
Reset button
Press for at least 3 seconds: the camera is completely reset and goes back to default settings.
2 Simplified EU declaration of conformity
Hereby, URMET S.p.A. declares that the radio equipment type: camera 1099/211B is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following
internet address:
3 Installation
It is advisable to proceed as follows for correct camera installation and configuration:
1
Make sure that no units are powered before starting the installation procedure. It is advisable
to install and configure one camera at a time if you are installing multiple cameras on the same
network.
2
Connect the camera to the network. It is advisable to check that the Wi-Fi signal received by
the camera is higher than or equal to 60.
3
Position the camera in a point on the wall or other surface and adjust the bracket to frame the
required scene.
4
If you want the camera to record and store video files on a microSD card (not included), plug
the card into the slot when the camera is powered off. Power on the camera and use the app to
format the card before starting the recording function.
DS1099-149
www.urmet.com
8
Publicité
