Publicité
Les langues disponibles
Les langues disponibles
Installation
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON
to relieve water pressure.
DO NOT use pipe dope
or thread sealant on drain
assembly, or any plastic
threaded components.
1) Insert IPS inlet connections (I) and
mounting gasket (J) into sink holes.
2) Install mounting nuts (K) onto IPS
inlet connections (I).
1
K
1
1
1
3) Push Pop Install: Insert drain
body (L) into drain opening. From
below, Tighten locking nut (O)
with gasket (M) and washer (N)
to flange. Tighten tail nut (Y) with
washer (X) to secure tail pipe (Q).
DO NOT overtighten.
Plumbers Putty
I
J
4) Attach supply lines to IPS inlet
connections (I). Using a wrench,
finish with one-half turn. DO NOT
overtighten.
I
2
L
1
M
N
2
O
X
3
Q
Y
1
I
1
2
3
5) Attach supply lines to shut-off
valves and hand tighten. Using a
wrench, finish with one-half turn.
DO NOT overtighten.
1
1
6) Turn on water supplies. Remove
aerator (H) and flush lines free of
debris. Check for leaks.
H
2
Publicité
