Rowenta EP8990D0 Mode D'emploi page 15

1800111731 EP8990E0.qxd
9- TRIM AND EVEN OUT HAIR IN THE BIKINI AREA
Put the bikini line trimmer head in place (21). Your bikini line trimmer head is equipped
with 3 combs to lift long hairs for cutting by the blade.
Choose the desired comb before switching the appliance on.
IMPORTANT
For your first use, we advise you to use the comb for the longest cutting length.
- If you want a hair length of approximately 9 mm, use the largest comb.
- If you want a hair length of approximately 3 mm, use the smallest comb.
- If you want a hair length of approximately 6 mm, use the medium-sized comb.
IMPORTANT
a
If your skin becomes irritated, apply some talc after use.
• For a neat bikini outline
If you want a closer shave, use the bikini line trimmer head without
the comb:
Set the switch to 0 and plug in the appliance.
Push to remove the comb (b).
Next, switch the appliance on using the on/off switch.
Hold the appliance upright and move it slowly against the hair.
IMPORTANT For greater effectiveness, pull hair outward with the other hand to make it
stand out. This will give you a more precise shave with little irritation.
10- CLEANING THE APPLIANCE
1
2
25/10/07
Slide the comb into the two grooves on the trimmer head (a), then
set the switch to 2.
Hold the appliance upright so that you can see the appliance name,
and move it slowly against the hair.
4. Shake the epilator head vigorously and dry it
with a towel before fitting it to the epilator
again.
You can also use the small cleaning brush sup-
plied.
13
11:19 Page 13
• Cleaning the epilator head:
1. Unplug the epilator.
2. Press the release button on the
head and remove the epilator head.
3. Rinse the epilator head under cold
running water by turning it for 5 to
10 seconds.
b