Zyxel ZyWALL USG 1000 Guide De Démarrage Rapide page 3

3 Connecting the Hardware
Make sure that the power switch on the rear panel is turned off before you make the hardware connections.
1 It is recommended that you configure the ZyWALL before using it to protect your network. Use an Ethernet
cable to connect a computer to port 1.
2 Use another Ethernet cable(s) to connect port 2 and/or port 3 to an Ethernet jack with Internet access.
3 Use the included power cord to connect the power socket on the rear panel to a power outlet.
4 Push the power switch to the on position and look at the front panel. The PWR light turns on. The SYS light
blinks during system testing and initialization and then stays on when the system is ready.
4 Web Login
1 Launch your web browser and go to http://192.168.1.1
(the ZyWALL automatically redirects you to https://
192.168.1.1).
5 1
ENGLISH
2
Internet
3