Section 1 Setup & First Brew - Keurig Hot K3000SE Manuel D'utilisation

SECTION 1
You cannot use your Keurig
IMPORTANT:
until it has been set up for its first use.
If the brewer has been exposed to temperatures
NOTE:
below freezing, allow the brewer at least two hours
to reach room temperature before brewing. A frozen
or extremely cold brewer will not operate.
This brewer is designed to handle local
CAUTION:
water pressures from 40 psig up to 125 psig.
Consult a licensed plumber for water pressures in
your area. Use plumbing fittings and tubing
specified to withstand 125 psig.
Keurig requires the use of an external
®
WARNING:
water filter such as the Omnipure KQ8AWater
Filter, available from Keurig Green Mountain,
Inc. (#5572). Failure to use a filter invalidates the
brewer Warranty.
Setup & First Brew
brewer
®
Plumbing Fitting Connections
Screws ( 4 x )
Filter Mounting Bracket
IN PORT
Shut-off Valve
LLDPE Tubing
Omnipure KQ8A
Water Filter
Remove all pieces of packing tape from the brewer and Drip Tray.
1.
Remove the clear plastic film from the LCD Display.
filter (KQ8A, #5572) can be mounted on the rear surface of the brewer using
the mounting screws provided.
Attach a Threaded Straight Adapter (fig. 1) to each of the ports on the
2.
Omnipure KQ8A Water Filter and tighten using an
Make sure the connections are secure but do not over tighten.
6
1
fig.
OUT PORT
Threaded Straight Adapter
Stem Elbow Fitting
LLDPE Tubing
/ " Male Garden
3
4
Hose Connector
NOTE: An external
/ " (18 mm) wrench.
11
16