Publicité
Les langues disponibles
Les langues disponibles
V 3.01
2. Adjusting the Secondary Handle.
While gripping the rotating part on secondary handle (#4) tightly, turn it in a downward
direction (Fig. 10). Push the secondary handle down until the desired angle is set in one
of five angles. There is a downward arrow marked on this handle. You can follow the
direction of the arrow to adjust the angle (Fig. 11). You will hear a click sound. Release the
rotating part of the secondary handle.
3. Adjusting the Angle of the Cutting Head.
While firmly holding the main handle in one hand and one foot step on the top of the
cutting head, push shaft backwards or forwards to adjust the cutting angle to one of
6 positions (Fig 12).
4. Adjusting the Cutting Head for Trimming or Lawn Edging.
The trimmer is designed to offer both trimming and edging function. To switch from
trimming to edging, press the Edger function switch (#11) on the tool, firmly holding
the telescopic shaft in one hand and turn to the left (Fig. 13 & 14).
5. Switching On.
•
To prevent the tool accidental starting, this grass trimmer is designed with a
safety lock off mechanism.
•
To turn the grass trimmer on use your thumb to press the lock off switch (#2)
while holding the lock off switch squeeze the on/off trigger switch (#1).
•
To turn the grass trimmer off, release the on/off trigger switch.
TRIMMING TIPS
WARNING! Remove battery from grass trimmer before performing adjustments. Make sure that
the work area is free of rocks, debris, lines and other foreign objects.
1. Lower the tree guard to prevent the cutting head from getting too close to an object such
as a tree trunk or wall and causing damage to the Trimming Spool (#9).
2. Start the trimmer before approaching the grass to be cut.
3. Cut the grass by moving the trimmer from the right to left and proceed slowly, keep
the trimmer inclined forwards at an angle of about 30 degrees. Light cuts are better
than heavy cuts as they allow the cut grass to fall away from the cutting head.
4. High grass should be cut in layers always beginning from the top. Do not cut damp
or wet grass. This will overload your trimmer.
5. Watch out for kickbacks and sprays of debris in the event of an impact with hard objects.
6. After finishing the cutting operation, keep the head close to ground level, release the
switch and allow the motor to come to a complete standstill. Place the grass trimmer on
the ground and remove the battery.
CHARGING YOUR LITHIUM ION BATTERY
The battery was shipped in a low charge condition and requires charging prior to use.
•
Plug the charger (#14) into a power outlet.
•
The power light on the charger will turn green showing that power is being
supplied to the charger.
•
Slide the battery into the charger (Fig. 15). The battery only fits one way.
•
The charging light on charger will turn red when the battery is charging.
•
The charging light on charger will turn green when the battery is fully charged.
•
The battery takes 1 hour to charge. Slide the battery out from the charger after no more
than 90 minutes.
•
Unplug the charger from the power outlet when the charger is not in use.
•
If the battery is completely discharged, 90 minutes charging time will be required to fully
recharge it.
8
All manuals and user guides at all-guides.com
10 in. Cordless Grass Trimmer
8467946
For technical questions call 1-800-665-8685
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Publicité
