Beamz MHL45 Manuel D'instructions page 4

DISPLAY
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal
(+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
4
The control board offers several features: you can simple set the starting address, run
the pre-program program or make a reset. The main menu is accessed by pressing the
Mode/Esc-button, browse through the submenu by pressing Up or Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection by
pressing the Enter-button.
You can leave every mode by pressing the Mode/Esc-button. The functions provided
are described in the following schedule.
DISPLAY MENU
Mode Description
ADDR
DMX start address
CHND Channel Mode
SLND Master / Slave
SOUN
Sound Sensitivity
AUTO
Auto Mode
STBY Standby / Pause
PAN Invert X-Motor
TILT Invert Y-Motor
Digital display off after 10
LED
seconds
DISP
Rotate Digital display
TEST
Test function
HOUR Machine on-time
RSET Reset
A001-A512
6Channels
11Channels
NAST
SL1
SL2
0-100
NO
YES
NO
YES
NO
YES
NO
YES
ON
OFF
ON
OFF