Additional Information
Troubleshooting
If you have any pr oblem while viewing your TV , please check the following
troubleshooting guide. If the pr oblem persists, contact your Sony dealer .
Symptom
Snowy picture
Noisy sound
Distorted picture
Noisy sound
Good picture
Noisy sound
No picture
No sound
Solutions
• Check the antenna cable and connection
on the TV, VCR and at the wall. (page 4)
• Press SELECT until "MANUAL
PROGRAM" appears on the screen then
preset the channel again. (page 9)
• Check the antenna type (VHF/UHF).
Contact a Sony dealer for advice.
• Adjust the antenna direction. Contact a
Sony dealer for advice.
• Try using a booster.
• Turn off or disconnect the booster if it is
in use.
• If the sound of all the channels are
noisy, press AUTO PROGR to preset the
channels again. (page 8)
• If the sound of some channels are noisy,
select the channel, then select the
appropriate TV system. (page 9)
• Check the power cord, antenna and the
VCR connections.
• Press u (power).
• Press U (main power) on the TV to turn
off the TV for about five seconds, then
turn it on again.
Possible cause
• The connection is loose or
the cable is damaged.
• The channel presetting is
inappropriate or
incomplete.
• The antenna type is
inappropriate.
• The antenna direction
needs adjustment.
• Signal transmission is low.
• Broadcast signals are too
strong.
• The channel presetting is
inappropriate or
incomplete.
• The TV system setting is
inappropriate.
• The power cord, antenna
or VCR is not connected.
• The TV is not turned on.
continued
Additional Information
19