Publicité
Les langues disponibles
Les langues disponibles
ND 1075-1 61-360 Instructions
Resistor Color Code Table
1st
2nd
Color
Digit Digit
Multiplier
Black
0
0
Brown
1
1
Red
2
2
Orange
3
3
Yellow
4
4
Green
5
5
100,000
Blue
6
6
1,000,000
Violet
7
7
10,000,000
Gray
8
8
100,000,000
White
9
9
1,000,000,000
Gold
Silver
No Color
Example:
1st color band is blue so the first digit is a 6
2nd color band is red so the second digit is a 2
3rd color band is yellow so multiply 62 x 10,000
4th color band is gold so the tolerance is ±5%
Your Resistor value is 620,000 Ohms (620KΩ)with a tolerance
of ±5%.
To Verify Continuity:
A continuity test ensures that all circuit connections are intact.
1. Plug the test leads into the meter inputs as indicated in the
diagram below.
2. Turn the power off to the circuit or device that is to be veri-
fied.
3. Select the continuity function
switch position below. The continuity function is located at
the 200Ω setting.
Page 7
All manuals and user guides at all-guides.com
3/9/06
4:51 PM
Tolerance
(Percentage)
1
10
100
1,000
10,000
+/- 5%
+/- 10%
+/- 20%
on the meter. See
Page 7
To Verify Continuity:
4. Test for continuity by connecting the meter to the circuit.
5. If the beeper sounds the circuit is complete.
Continuity Beeper
(beeps at resistance <30 Ω )
Meter Setup:
Circuit Connection:
Red
Black
Diode Testing:
To ensure a proper functioning diode, the meter will develop a
voltage across the component from a test current. The diode
test function allows measurements of forward voltage drops
across diodes and transistor junctions.
1. Turn off power to the device or circuit that is being tested
and discharge all capacitors.
2. Plug the leads into the meter inputs as indicated in the fol-
lowing diagram.
3. Select the diode
function on the meter.
4. Connect the red rest probe to the anode (+) and the black
test probe to the cathode (-) of the diode. If the diode is
shunted by a resistor of 1K Ohm or less, it must be
removed from the circuit before taking the measurement.
Page 8
Publicité
