Graef TO 100 Notice D'utilisation page 8

Toaster TO 100 / TO 101
level, non-slip and heat resistant base
that has sufficient load bearing capacity.
■
Select the place of location so that chil-
dren cannot reach the hot surfaces of the
EN
unit.
■
The unit is not intended for installation in
a wall or a built-in cupboard.
■
Do not set up the unit in a hot, wet or
moist environment.
■
The electric socket must be readily acces-
sible so that the power cord can be easily
unplugged.
■
The unit emits a great amount of heat to-
wards the top. Never place the unit on a
cupboard, under curtains or next to com-
bustible materials.
■
Never place the unit near paper, fabric or
similar materials. The bread can burn.
Before the first use
When using for the first time, operate the
unit 1 - 2 times at the highest level without
any toast as it is possible that a slight odour
will develop due to possible dust remnants
on the heating spirals.
Making toast
Connect the unit to the mains supply:
■
Put the toasting goods into the slot.
■
Select the desired degree of browning (1
light - 6 very dark)
■
Press the lift button down until it latches.
Extra-lift
The extra-lift eases removing the toasted
goods.
Lift the lift button and take out the toasted
goods.
Bread slice centring
It does not matter if you want to toast large
or small slices of bread, or thick or thin ones,
the bread slice centring device always posi-
tions your toasted goods at the right place
and ensures uniform browning on both
sides.
Attachment for buns
The attachment for buns can also be used
as a warmer for your freshly toasted bread.
Simply place the toasted goods on the bun
attachment.
8
Defrost feature
important!
■
It is not necessary to adjust
the control knob as the de-
frost time is preset.
■
Put the frozen toasting goods into the
slot.
■
*
Press the button.
■
Press the lift button down until it latches.
Stop feature
■
Press the stop button.
■
The toasting process is interrupted.
Bun warm-up feature
To warm up buns, proceed as below:
■
Place the bun attachment on the unit.
■
Place the buns on the bun attachment.
■
Set the browning degree control to be-
tween steps 2 and 3.
■
Press the lift button down until it latches.
■
When the lift button returns to the top,
turn the buns over once and repeat the
process.
cAUTION
■
The attachment for buns is hot
during toasting; do not touch it.
cleaning
■
Clean the exterior of the unit with a soft,
moist cloth. If heavily soiled, a mild deter-
gent can be used.
■
Crumbs that have fallen down collect in
the crumb tray.
■
Press the "Push" button.
■
Remove the crumb tray and empty the
crumbs.
■
Replace the crumb tray.
Disposal
At the end of its service life, this product
must not be disposed through normal do-
mestic waste; rather it must be disposed
at a collection point for recycling electronic
domestic refuse. The symbol on the product