Publicité
Les langues disponibles
Les langues disponibles
Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated instructions. If you
have any questions regarding your product installation call 1-800-Pfaucet (1-800-732-8238)
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price
Pfister recommends calling a professional if you are uncertain about installing
this product!
This product should be installed in accordance with all local and state plumbing
and building codes.
WARNING: This product has been designed for use with the Price Pfister
0X8 series pressure balancing valve. It will not work with any other product.
Please review the 0X8 valve installation instructions before installing this
product.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are
usually found near the water meter. If you are replacing an existing unit, remove
the old unit and clean the mounting surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Philips head screwdriver
• Adjustable wrench • Pipe wrench
• Flashlight
• Cloth
Your installation will require a pipe nipple for the spout installation as well as
other additional tools.
This product comes with a Hex Wrench for tightening a set screw into the Hub.
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
4
F
G
J
E
D
A
A Gasket Flange
B Trim Flange
D Retainer Sleeve
E Extension Stem
G Set Screw
H Hex Wrench
K Shower Arm
L Shower Head
If any of these items are missing, please contact Price Pfister Consumer Service
at 1-800-Pfaucet (1-800-732-8238).
5 WORK AREA INSPECTION
Verify that the hole sizes and positions in the wall are correct.
L
C
K
H
B
M
C Washer
F Hub & Handle
J Diverter Spout
M Shower Flange
ENGLISH
.
INSTALLATION STEPS
5
30"
Tub & Shower
6 PLASTERGUARD OPTIONS
6
A
6B
B
6C
A. For installation using plasterguard, knock out Center Section (6B) from
Plasterguard (6A). The use of plasteguard is optional for standard installations.
B. For installation without plasterguard, remove Screws (6C), and
Plasterguard (6A).
2
1
1
/
" Dia.
4
3
4
/
" Dia.
4
4" Dia. for Thin
48"
Wall Installation
Tub & Shower
8" Min.
48"
Shower Only
1
1
/
" Dia.
4
6A
6A
30"
Shower Only
Publicité
