Publicité
Installation and Pairing of Repeaters: 99-RX02
The RX02 Repeaters are to be plugged directly into a 120V power outlet
1.
Turn on the main wall control by pressing the ON/OFF button
RX02 with GDXPL02 Controls: Press the left and right buttons simultaneously on the main wall
2.
control (
and RESET buttons). The screen will go blank and the wireless symbol
flashing on the bottom right of the display. This indicates that the main control is now in pairing
mode. RX02 with GBC02, GBC03 or GBC04 Controls: Press the left and right buttons
simultaneously on the main wall control (
control). The bottom row of 3 LED's will begin flashing. This indicates that the main control is now
in pairing mode.
3.
The RX02 Repeater must be powered within 16" of the main wall control for pairing. If an outlet is
not available an extension cord should be used to power the repeater initially for pairing.
4.
Plug the RX02 Repeater into the power outlet. The green light will flash after approximately 12
seconds indicating that the repeater is paired with the main wall control.
5.
Press the ON/OFF button on the main wall control to exit pairing mode and the Repeater may
now be unplugged and moved to its permanent location.
To pair additional RX02 Repeaters with the same wall control, repeat steps 1-5 until
all Repeaters have been paired.
When installed in its permanent location, the green LED will remain solid to indicate
the best location and the Repeater can be moved farther if required. The green LED
will flash to indicate it is in a good location. A red light indicates the Repeater is out
of range and needs to be moved closer to the main wall control.
Installer Selectable High Speed Settings
The circuit board on this unit has adjustable DIP switches for the selection of speeds
Hi1, Hi2 or Hi3. The factory setting is Hi3. Refer to the specification page found online at;
www.lifebreath.com for the airflow rates on Hi1, Hi2 and Hi3. Note: Low speed is not adjustable.
Description
Hi 3 (factory default)
Hi 2
Hi 1
Illustration of DIP switches 3
and 4 in the ON position
(factory setting
).
Functionality of DIP
Switches 1 and 2
DIP 1 ON
R2000 defrost cycle disabled (factory setting)
DIP 1 OFF R2000 defrost cycle enabled
DIP 2 ON
recirculate defrost models
DIP 2 OFF damper defrost and fan defrost models
Switch 1
Factory Setting "ON"
Factory Setting "ON"
Factory Setting "ON"
.
and either
or
buttons, depending on the main
Switch 2
Leave on factory setting
Leave on factory setting
Leave on factory setting
will appear
RX02
Repeater
Power
Plug
Switch 3 Switch 4
ON
ON
OFF
ON
ON
OFF
16
Publicité
