Guide of Manual
1. Please read and follow this instruction and safety warning
carefully. Use the product in accordance with the intended purpose.
2. Please save the instruction for the future reference. When
transferring the product to the third party. Please hand on the
instruction and safety warning as well.
3. The contents in this instruction, including the texts and pictures
are as detailed as possible.
4. For the purpose of summarizing, not all possible variations and
installation methods are included in the instruction. During the
assembly process, if you need further information, or has special
difficulties, which are not included in the instruction, please consult
with our customer service team.
Notes
1. The product is mainly used as a mirror and storage cabinet. The
user must strictly assemble and use the product in accordance with
the provisions of the manual. The seller does not assume any
responsibility or liability with respect to any damage caused by
incorrect assembly or improper use.
2. Please check if the cabinet body is intact and if accessories are
complete before mounting. Do not place the edge of the unwrapped
cabinet on the floor to avoid any fray or damage.
3. When mounting the wall cabinet, please make sure that the holes
away from electrical wires or water pipes, in order to prevent
unexpected damages or losses.
4. Follow the assembly steps shown in the diagram to position and
adjust the parts, then gradually tighten all screws (Note: do not
tighten excessively).
5. The cabinet must be mounted on the wall or the door with
supplied or self-purchased accessories.
02
1
Mounted on The Wall
According to the distance
between the two holes in the
back of the jewelry cabinet,
measure and mark two
horizontal points on the wall, and
then drill them with an electric
drill. Insert anchors D into the
holes, and then put screws E into
the anchors. Please note that the
screws cannot be all screwed in,
and must leave enough length
for hanging jewelry cabinet (The
length can be properly adjusted).
EN
03