Publicité
Les langues disponibles
Les langues disponibles
Mode B : Straight Pole
Note: This installation applies to the poles with a diameter of <1>40-60MM.luminaire.
Installation C: Curved Pole
5. GENERAL SAFETY NOTES
This device is not intended for use by persons (including children) with limited physical, sensory or
mental capabilities or with no experience or knowledge, unless under the supervision of a person in
charge of the device. their safety or if they have received instructions from a person on how the device
should be used.
Children should be supervised to make sure they do not play with the device.
If a power cable is damaged, it must be replaced by a professional to avoid any risk of injury or accident,
as well as damage to the device.
Always unplug your appliance before cleaning and if it is defective.
Never immerse the device in water. It is not suitable for underwater use. Risk of electrocution!
Do not operate the appliance if it has fallen into the water and the plug or appliance is damaged.
Make sure that neither the power cable nor the appliance is placed on hot surfaces or near sources of
heat. Lay the power cable so that it does not come into contact with hot or sharp objects. Risk of electric
shock !
Distribué par / Distribuito da / Distributed by / Vertrieben von NETELEC SRL FR - rue Philemon Laugier - 83400 Hyeres les Palmiers
1. Prepare lamp, accessories and tools well firstly.
2. Remove the nut spacer of U-shaped brackets. (Picture 1)
3. Use the U-shaped brackets to fix the lamp on the pole. (Picture 2)
4. Loosen the screws at both ends of the bracket and adjust the angle
of the lamp as needed, which is 20° adjustable in clockwise direction
and 10° adjustable in counterclockwise direction, then tighten the
screws. (Picture 3 4)
1. Prepare lamp, accessories and tools well firstly.
2. Loosen the screws and take off the bracket. (Picture 1 2)
3. Move the cover of lamp socket. (Picture 3)
4. Fix the arch-shaped bracket onto the lamp socket ( do not
Iock first). (Picture 4)
5. Set up the lamp onto the lamp pole. (Picture 5)
6. Adjust the lamp and balance it, then Iock the arch-shaped
bracket. (Picture 6)
Note: This installation applies to the poles with a diameter of
<1>40-50MM.
Publicité
