Maintenance
Use a soft dry cloth to wipe the surface of the unit clean .
For stubborn smudges, use a damp cloth that has been thoroughly
wrung out to remove excess moisture .
o Never spray liquid directly on this unit .
o Do not wipe with chemical cleaning cloths, thinner or other
chemical agents . Doing so could damage the surface .
o Avoid allowing rubber or plastic materials to touch the unit for
long periods of time because they could damage the cabinet .
V
For your safety, disconnect the power cord from
the outlet before cleaning.
Precautions for use
o This unit is very heavy, so take care to avoid injury during installation .
o Do not install this unit in a location that could become hot . This
includes places that are exposed to direct sunlight or near a radia-
tor, heater, stove or other heating equipment . Moreover, do not
place it on top of an amplifier or other equipment that generates
heat . Doing so could cause discoloration or deformation .
o In order to enable good heat dissipation, leave at least 20 cm (8")
between this unit and walls and other equipment when installing
it . If you put it in a rack, take precautions to prevent overheating
by leaving at least 5 cm (2") open above the top of the unit and at
least 10 cm (4") open behind the unit .
Failure to provide these gaps could cause heat to build up inside
and result in fire .
o Place the unit in a stable location .
o Do not place anything on top of the unit .
o The voltage supplied to the unit should match the voltage as
printed on its back . If you are in any doubt regarding this matter,
consult an electrician .
o Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock . If a foreign object should
get into the unit, contact your dealer .
o When removing the power plug from an outlet, always pull
directly on the plug . Never pull on the cord itself .
7