Koss MS2015 Mode D'emploi page 5

INSTALLATION
4. After removing the outer trim ring, press
OPEN/CLOSE button again to slide
the front panel up. Then insert both of
the supplied keys into the slots at the
left and right sides of the unit, then pull
the unit out of the dashboard.
All manuals and user guides at all-guides.com
5
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan or a Toyota,
follow these mounting instructions.
Use the screw holes marked T (Toyota)
or N (Nissan) located on both sides of the
unit to fasten the unit to the factory radio
mounting brackets supplied with your
vehicle.
Side view showing
Screw Holes marked T, N
Factory Radio
Mounting
Bracket
Screw
Hook
To fasten the unit to the factory radio
mounting brackets.
1. Use a screwdriver to loose the hook's
screws on the front left and right sides
of the unit and remove the hooks.
2. Align the screw holes on the bracket
with the screw holes on the unit, and
then tighten the screws (5x5mm) on
each side.
Note: the outer trim ring, sleeve and the
metal strap are not used for method B
installation.
Screw
Hook
Dashboard or
Console