Koss MS2015 Mode D'emploi page 4

INSTALLATION
Sleeve
L Key
R Key
4. Mount the sleeve by inserting the sleeve
into the opening of the dashboard and
bend open the tabs located around the
sleeve with a screwdriver. Not all tabs
will be able to make contact, so
examine which ones will be most
effective. Bend open the appropriate
tabs behind the dashboard to secure
the sleeve in place.
Tabs
Screwdriver
5. Reconnect the wire harness and the
antenna and be careful not to pinch
any wires or cables.
6. Slide the unit into the sleeve until it
locks into place.
7. To further secure the unit, use the
supplied metal strap to secure the back
of the unit in place. Use the supplied
hardware (Hex Nut (M5mm) and Spring
Washer) to attach one end of the strap
to the mounting bolt on the back of
the unit. If necessary, bend the metal
strap to fit your vehicle's mounting
area. Then use the supplied hardware
(Tapping Screw (5x25mm) and Plain
Washer) to attach the other end of
metal strap to a solid metal part of the
vehicle under the dashboard. This strap
also helps ensure proper electrical
grounding of the unit.
All manuals and user guides at all-guides.com
Dashboard
Sleeve
4
Note: to install the short threading terminal
of the mounting bolt to the back of the
unit and the other long threading terminal
to the dashboard.
Metal Strap
Mounting Bolt
8. Reconnect the cable to the vehicle
battery's negative (-) terminal.
Removing the unit
1. Remove the metal strap attached to
the back of the unit (if attached).
2. Press the OPEN/CLOSE button to
slide the front panel down.
Open
3. Insert fingers into the groove in the
right side of the outer trim ring and
pull out to remove the outer trim ring.
(You can also remove the outer trim
ring from the left side.)
Outer trim ring
Spring Washer
Hex Nut
Plain Washer
Tapping Screw