Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

All manuals and user guides at all-guides.com
MS2015
OWNER'S MANUAL
Mobile Audio System
• PLL Synthesizer Stereo Radio
• Digital Compact Disc Player
• Automatic Memory Storing
• Slide Down Detachable Panel
• Preset Equalization
• Remote Control

Publicité

loading

Sommaire des Matières pour Koss MS2015

  • Page 1 All manuals and user guides at all-guides.com MS2015 OWNER’S MANUAL Mobile Audio System • PLL Synthesizer Stereo Radio • Digital Compact Disc Player • Automatic Memory Storing • Slide Down Detachable Panel • Preset Equalization • Remote Control...
  • Page 2 All manuals and user guides at all-guides.com CONTENTS Installation ...........3 Playing all tracks in random ....11 Take out screw before installation..3 Selecting tracks by DIN Front-Mount (Method A) ....3 AMS/MP3 button......11 Installing the unit .......3 Display information......12 Removing the unit......4 Disc notes ...........12 DIN Rear-Mount (Method B) ....5 Remote Control Handset....13...
  • Page 3 All manuals and user guides at all-guides.com INSTALLATION Notes: TAKE OUT SCREW BEFORE INSTALLATION • Choose the mounting location where Before install the unit, please remove the the unit will not interfere with the two screws. normal driving function of the driver. Take out screws before installation •...
  • Page 4 All manuals and user guides at all-guides.com INSTALLATION Sleeve Note: to install the short threading terminal L Key of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard. Spring Washer Hex Nut Metal Strap Mounting Bolt R Key...
  • Page 5 All manuals and user guides at all-guides.com INSTALLATION 4. After removing the outer trim ring, press DIN REAR-MOUNT (Method B) OPEN/CLOSE button again to slide If your vehicle is a Nissan or a Toyota, the front panel up. Then insert both of follow these mounting instructions.
  • Page 6 All manuals and user guides at all-guides.com USING THE DETACHABLE FRONT PANEL To Detach the Front Panel 1. Press the OPEN/CLOSE button, the front panel will slide down. Bottom Button 2. When the panel bracket is in slide up position, insert a side of the front Open panel to its proper position and push 2.
  • Page 7 All manuals and user guides at all-guides.com WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR IGNITION SWITCH (ACC+) (BROWN) Rch RED FRONT RCA LINE OUTCABLE CHOKE MEMORY YELLOW BACK-UP (B+) Lch WHITE BLACK (GREY) GROUND (B–) Rch RED REAR RCA LINE OUT CABLE Lch WHITE POWER BLUE...
  • Page 8 All manuals and user guides at all-guides.com OPERATION LOCATION OF KEYS 7 10 15 11 13 19 1. MON Button 13. BND/LOU 2. LOC Button 14. Preset button 3. MUT Button 15. Display Button (DSP) 4. LED 16. MANU/SKIP Search DOWN Button 5.
  • Page 9 All manuals and user guides at all-guides.com OPERATION • SWITCHING THE UNIT ON/OFF • RESET FUNCTION Switch on the unit by pressing any RESET button (12) must be activated button (except OPEN/CLOSE button with either a ball point pen or thin (7)).
  • Page 10 All manuals and user guides at all-guides.com OPERATION stations are stored into the • PAUSING PLAYING corresponding preset number button Press PAU button (20) to pause CD positions. player. Press it again to resume play. - Program Scanning • PREVIEWING ALL TRACKS Press AMS button (18) shortly to Press SCN button (21) to play the first scan preset stations.
  • Page 11 All manuals and user guides at all-guides.com OPERATION • PREVIEWING ALL TRACKS buttons to list all songs under this Press SCN button (21) to play first several directory and select the title. seconds of each track on the current disc. - Press BND/LOU (ENT) button to confirm Press again to stop intro and listen to track.
  • Page 12 All manuals and user guides at all-guides.com OPERATION KEY Assigned IN Searching mode (Table 1) DISC NOTE A. Notes on discs: Mode Select 1. Attempting to use non-standard shape discs (e.g. square, start, heart) may BND/LOU ENTER damage the unit. Be sure to use round shape CD discs only for this unit.
  • Page 13 All manuals and user guides at all-guides.com REMOTE CONTROL HANDSET FUNCTION KEYS & CONTROL 1. PWR = Power ON/OFF Button 2. DSP (0) = Display Button (_, –, +, 0) 3. SEL = Select Button (Character Shift Right) 4. VOL = Volume Up Button [Character Select (A, B ~ 8, 9, 0)] 5.
  • Page 14 All manuals and user guides at all-guides.com SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 165 (D) x 50 (H) Tone Controls : ± 10 dB - Bass (at 100 Hz) : ±...
  • Page 15 All manuals and user guides at all-guides.com TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is not on.
  • Page 16 All manuals and user guides at all-guides.com Error Code showing on display Cause Remedy ERROR 1 Mechanism problem Press “RESET” button. ERROR 2 Playback errors: Dirty disc Clean the disc and load it as instruction manual mentioned. Disc is loaded up side down Load disc with label facing up.
  • Page 17 All manuals and user guides at all-guides.com MS2015 GUIDE D’UTILISATION Système de radio mobile • Radio stéréo à boucle de verrouillage de phase ‘PLL’ • Lecteur de disques compacts numériques • Programmation automatique des stations en mémoire • Face amovible escamotable •...
  • Page 18 All manuals and user guides at all-guides.com TABLE DES MATIÈRES Installation ...........3 Effectuer une pause de la lecture ..11 Retirer les vis avant l’installation...3 Entendre le début de chaque piste .11 Installation DIN par l’avant (méthode A) ..3 Répéter la même piste ....11 Installer l’appareil.......3 Jouer toutes les pistes dans le Retirer l’appareil.........4...
  • Page 19 All manuals and user guides at all-guides.com INSTALLATION Remarques : RETIRER LES VIS AVANT • Sélectionnez l’emplacement de L’INSTALLATION montage de façon à ce que l’appareil Avant d’installer l’appareil, veuillez retirer ne nuise pas aux manoeuvres du les deux vis. conducteur.
  • Page 20 All manuals and user guides at all-guides.com INSTALLATION Manchon Remarque : pour installer la borne filetée Clé de gauche courte du boulon de montage à l’arrière de l’appareil et l’autre borne filetée longue au tableau de bord. Rondelle à ressort Écrou hexagonal Sangle de métal Boulon de montage...
  • Page 21 All manuals and user guides at all-guides.com INSTALLATION 4. Après avoir retiré la garniture extérieure, INSTALLATION DIN PAR L’ARRIÈRE appuyez de nouveau sur la touche (MÉTHODE B) OPEN/CLOSE pour glisser le panneau Si votre véhicule est un Nissan ou un avant vers le haut.
  • Page 22 All manuals and user guides at all-guides.com UTILISER LA FACE AMOVIBLE Dégager la face amovible 1. Appuyez sur la touche d’ouverture et de fermeture OPEN/CLOSE et la face amovible glissera vers le bas. Bouton inférieur 2. Lorsque le support de la face est glissé...
  • Page 23 All manuals and user guides at all-guides.com CONNEXION DES CÂBLES UNITÉ PRINCIPALE CONNECTEUR D’ANTENNE Commutateur ROUGE d’allumage (BRUN) (ACC+) CÂBLE DE SORTIE DE LIGNE RCA AVANT Canal droit ROUGE CIRCUIT Sauvegarde de la JAUNE mémoire (B+) Canal gauche BLANC DE DÉPART (GRIS) NOIR MISE À...
  • Page 24 All manuals and user guides at all-guides.com FONCTIONNEMENT EMPLACEMENT DES COMMANDES 7 10 15 11 13 19 Touche ‘MON’ 14. Touches des préréglages Touche de syntonisation locale ‘LOC’ 15. Touche de l’affichage ‘DSP’ Touche de sourdine ‘MUT’ 16. Touche de recherche manuelle/saut Voyant à...
  • Page 25 All manuals and user guides at all-guides.com FONCTIONNEMENT • METTRE L’APPAREIL EN MARCHE-ARRÊT La touche de réinitialisation ‘RESET’ (12) doit ‘ON/OFF’ être activée à l’aide de la pointe d’un stylo ou Mettez l’appareil en marche en appuyant sur d’un petit objet métallique. n’importe quelle touche (à...
  • Page 26 All manuals and user guides at all-guides.com OPERATION cycle. Les six stations dont la réception est la Appuyez sur la touche ‘PAU’ (20) pour effectuer plus forte seront entrées en mémoire. Vous une pause du CD. Appuyez de nouveau sur pourrez y accéder en appuyant sur la touche cette touche pour reprendre la lecture.
  • Page 27 All manuals and user guides at all-guides.com OPERATION • CHOISIR LES PISTES EN UNE SEULE ÉTAPE qui appuie sur les touches correspondantes Pendant la lecture d’un CD, appuyez sur la énumérées au tableau 1 ci-dessous. touche (16) ou sur (17) pour vous Voici une explication de ceci : déplacer vers la piste précédente ou suivante.
  • Page 28 All manuals and user guides at all-guides.com OPERATION • RENSEIGNEMENTS RELATIFS À REMARQUES SUR LES DISQUES L’AFFICHAGE A. Remarques relatives aux disques: Appuyez sur la touche ‘DSP’. Si les données 1. Ne tentez pas de jouer des disques aux de l’étiquette ID3 TAG sont offertes, elles seront formes irrégulières (par exemple, de forme affichées en appuyant sur cette touche.
  • Page 29 All manuals and user guides at all-guides.com TÉLÉCOMMANDE TOUCHES DES FONCTIONS ET LES COMMANDES CORRESPONDANTES 1. PWR = Touche de mise en MARCHE-ARRÊT 2. DSP (0) = Touche d’affichage 3. SEL = Touche de sélection (Déplacement des caractères vers la droite) 4.
  • Page 30 All manuals and user guides at all-guides.com SPÉCIFICATIONS GÉNÉRALES Alimentation : 12 volts CC, masse négative Dimensions du châssis : 178 (L) ¥ 160 (P) ¥ 50 (H) Commandes de tonalité - Graves (à 100 Hz) : +/-10 dB - Aigus (à 10 KHz) : +/-10 dB Puissance de sortie maximum : 4 x 55 watts...
  • Page 31 All manuals and user guides at all-guides.com GUIDE DE DÉPANNAGE Avant de vérifier les points ci-dessous, vérifiez les raccords de vos fils. Si, après vérification de tous les points ci-dessous, le problème persiste encore, consultez le marchand qui vous a vendu l’appareil ou un centre de service autorisé. Solution Symptôme Cause...
  • Page 32 All manuals and user guides at all-guides.com Codes d’erreur apparaissant à l’affichage ERREUR 1 Cause Solution ERREUR 2 Problème du mécanisme Appuyez sur la touche de réinitialisation ‘RESET’. Erreurs de lecture; Le disque est sale. Nettoyez le disque et chargez-le selon les instructions du guide d’utilisation.