Publicité
Les langues disponibles
Les langues disponibles
Step 6: Next connect the plug that comes
out from the 'head' of the radiator to the
socket. Make this connection secure using
the protective box.
Step 7: Now place the 'head' of the radiator on/in
the highest stand, in such a way that the small
screw holes beneath the radiator head lie directly
over the screw holes at the top of the highest
stand and screw the head and stand together
firmly using 2x8mm screws. The electrical cable
and connection are now located in the stand.
Step 8: You can now set the height of your
terrace radiator by loosening the coupling nut a
little, pulling out the highest stand a little or letting
it drop and then fastening the coupling nut again
at the desired height.
Step 9: Now pull the underside of the excess
cable from the stand and secure the electrical
cable using two cable clamps and four 15mm
16
Step 5: Loosen the black coupling nut a little. You
can now pull the top stand from the middle stand. Pull
it around 25 cm out and firmly screw the coupling nut
back in place. The socket must continue to come out
from
the
top
stand.
screws
beneath
base.
In
doing
ensure that the cable in
the stand is not under
current. Allow the cable
the
this,
Publicité
