Verona VECTI365 Guide D'utilisation page 19

Fastening the cooktop to the counter
Turn the cooktop upside down and place it on a soft surface.
1
Spread the seal around the edges of the cooktop with the adhesive side facing down, as shown
2
in Figs. 6 and 7. Make sure that the whole perimeter is sealed. Cut off any excess material.
Mount the supplied clamps and screws onto the cooktop, as shown (without tightening the
3
screws) if not already fitted.
Place the cooktop into the cutout, then tighten the screws to clamp the cooktop securely to the
4
counter.
Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the
5
cooktop. Take care not to damage the countertop.
Note: if the countertop is thicker than 1
3⁄16
1 " (30 mm) and 1
Fitting the rear clamps
Securing the rear clamps
9⁄16
9⁄16
" (40 mm).
Adhesive side
1 2
Seal
Clamp Screw
" (40 mm), recess the underside to between
Front
Rear
Clamp position
Fig. 6 Preparing the cooktop before installation
Securing the front clamps
Clamp
Fig. 7 Fastening the cooktop to the counter
Seal
Seal
Screw
19