Publicité
Les langues disponibles
Les langues disponibles
5.
Operation
A
B
5.1.
Start bathing operation
FIRE RISK!
A fire risk exists when operating a sauna heater. Before starting the control system,
always check that there are no inflammable objects on or near the sauna heater.
1.
Switch On the control system at the main switch (B).
2.
Turn the controller of the bathing temperature (D) to the right to the desired temperature.
The LED (A) flashes during bathing operation.
The heating source is switched On. After the heating-up time the sauna is ready for bathing.
'
Setting the bathing temperature - see Section 6.1.
5.2.
Ending the bathing mode
1.
Switch Off the control system at the main switch (B).
The operation LED (A) goes out.
6.
Individual settings
6.1.
Setting the bathing temperature
Adjust the bathing temperature in the sauna with the controller for the bathing
temperature (D).
The standard bathing temperature is 85 °C - 95 °C.
The center position of the controller for the bathing temperature approximates 80 °C.
With IR-mode, the wall temperature is 50 °C up to a maximum of 60 °C. This leads to
a bathing temperature of approx. 35 °C to 40 °C.
The indicated cabin temperature in IR mode refers to an ambient temperature of
20 °C - 25 °C.
The temperature sensor is mounted in the warm air stream above the sauna heater.
An unavoidable temperature difference exists between the temperature sensor and the
control panel. Therefore the controller for the bathing temperature (D) is not equipped
with a scaled dial.
1.
Switch On the control system at the main switch (B).
2.
Turn the controller for the bathing temperature (D) all the way to the right until the stop. The
heating source heats the sauna cabin to maximum temperature.
.
In IR mode, the wall temperature is 50 °C to max. 60 °C.
3.
Determine the temperature for your personal comfort during the heating process in the sauna
cabin.
4.
Turn the temperature controller (D) on the control panel slowly to the left until a quiet click is
heard. The temperature for your personal comfort is now set.
5.
Mark the position of your personal comfort temperature on the housing.
PAGE 8
Unit/button:
C
D
Description:
A
Operation LED
B
Main switch
C Light switch
D
Controller bathing temperature
SL 028
50701101/02.13
Publicité
