Publicité
Les langues disponibles
Les langues disponibles
Step 2: Attach 4 MEDIUM BRACKETS [O] to the bottom of insert with 4 MEDIUM KD
SCREWS [P] as shown in fig. 11
Step 3: Tighten all screws.
Step 4: Move assembled unit to desired location. Unit should not be positioned in
area exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE is highly recommended in order to reduce
the risk of the fireplace being tipped over accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace is improperly handled, but is not a
substitute for proper adult supervision. Children should not be left unattended near
any heater.
1. Drill a 5/16" (8mm) hole in the wall. Insert the PLASTIC WALL ANCHOR into the
hole and gently tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantle close to the wall.
3. Attach the SAFETY CABLE to the mantle using the SCREW FOR MANTLE. See figure
12 and 13.
All manuals and user guides at all-guides.com
fig. 10
fig. 11
4. Use the SCREW FOR WALL to attach the other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace in-
sert has been properly connected to a grounded electrical outlet, it is ready to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
ON/OFF: Press this button for main power and flame effect. The indicator light will
turn on. See below for other control switches.
750W: For low heat function - Press this switch while the ON/OFF switch is in the on
position for low heat. The indicator light will turn on.
1500W: For high heat function - Press this switch while the ON/OFF switch and the
750W switch are in the on position for high heat. The indicator light will turn on.
Temperature Control: To adjust the temperature to your individual requirements, turn
the temperature control dial to the right (clockwise) to increase the desired tempera-
ture and to the left for lower temperature. This temperature control dial can only be
used while the ON/OFF switch and 750W & 1500W switches are in the ON position.
When the heater reaches to the desired temperature, the heater and 750W/1500W
indicator light will off but the fan still keeps working with air flow. Adjust this knob to
restart the heater.
Dimmer Control Knob: Turn the dimmer dial clockwise or counter clockwise to get the
desired flame intensity. The dimmer switch can only be used when the ON/OFF switch
is in the on position.
fig. 12
fig. 13
Publicité
