DNT WF Future4 pro Manuel D'utilisation page 21

6. Operation
6.1 Alarm function
Press the ALARM - button for at least three seconds to set the
alarm time. The text "ALM" and the hours display fl ash. Use the + -
button for the hour setting. By pressing the ALARM - button again,
the minute setting is activated. The minute display fl ashes. Use the +
- button for the minutes setting. Press the ALARM - button again to
end the setting mode for the alarm time.
Use the ALARM - button to activate or deactivate the alarm. When
the alarm is active, the alarm symbol "((( • ))) " is shown on the
display.
The alarm signal can be interrupted with the ALARM - button. Use
the SNOOZE - button to stop the alarm signal for fi ve minutes.
During this time, the alarm icon "((( • )))" fl ashes.
6.2 Outdoor temperatur
MIN/MAX can be resetted by pressing the SNOOZE key during 3
seconds.
6.3 Positioning the temperature transmitter:
The transmitter is supplied with a holder that may be at-
tached to a wall with the two screws supplied. The trans-
mitter can also be position on a fl at surface by securing the
stand to the bottom to the transmitter.
To wall mount: Mount at a sheltered place. Avoid direct rain
and sunshine.
1. Secure the bracket onto a desired wall using the screws
and plastic anchors.
2. Clip the remote temperature sensor onto the bracket.
All manuals and user guides at all-guides.com
Before permanently fi xing the transmitter wall
base, place all units in the desired locations to
check that the outdoor temperature reading is
receivable. In event that the signal is not recei-
- 21 -
6. Operation