Kobalt 2600503 Mode D'emploi page 10

ASSEMBLY INSTRUCTIONS
2. ASSEMBLING THE DISCHARGE CHUTE
2a. Push the chute deflector (E) until the latching
tabs on both sides click into the slots and the
posts on both sides click into the keyed holes.
3. INSTALLING THE CHUTE CONTROL ROD
3a. Align the holes on the upper chute control rod
(A) with the holes on the lower chute control
rod (B). Insert the hitch pin (DD).
NOTE: Position the discharge chute (I) so that it
faces forward.
3b. Insert the end of the chute control rod through
the keyed hole in the bracket that is attached
to the top of the middle handle (C).
Ensure that the handle (J) of the chute control
rod points upward and insert the rod into the
keyed hole in the back of the housing.
Firmly push the rod into the keyed hole in the
back of the housing until it snaps into place.
All manuals and user guides at all-guides.com
10
2a
Slot Keyed hole
Post
Latching tab
3a
DD
B
Holes
3b
I
C
Keyed hole
E
A
J
Keyed hole