EAS ELECTRIC EMH364CGB Guide D'utilisation page 35

How to Use the appliance
Automatic ignition with flame failure safety device
The appliance is fitted with a flame failure safety device on each burner,
which is designed to stop the flow of gas to the burner head in the event
of the flame going out.
To ignite a burner:
Press in the control knob of the burner that you wish to light

and turn it anti-clockwise to the maximum position.
If you keep the control knob depressed, the automatic ignition for

the burner will operate.
You should hold down the control knob for 15 seconds after the

flame on the burner has lit. If after 15s the burner has not lit, stop
operating the device and open the compartment door and/or wait at
least 1 min before attempting a further ignition of the burner. After
this 15-second
continue turning the control knob anti-clockwise until the flame is at
a suitable level. The operating position MUST be at a position
between the maximum and minimum position.
To switch the burner off, turn the control knob fully clockwise to

the gas off position.
In case of power failure, the burners can be lit by carefully using a

match.
interval, to regulate
11
the flame you should
V.5