Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
PROBLEM
Auger does not stop
within 5 seconds
after control lever is
released.
Discharge chute or
de ector does not work
(remote-manual).
Engine does not start.
Engine starts hard or
runs poorly.
Excessive vibration.
Scraper bar does not
clean hard surface.
Unit fails to propel itself Drive belt is loose or
Unit fails to discharge
snow.
20
All manuals and user guides at all-guides.com
LOOK FOR
REMEDY
Auger control cable out of
Adjust auger control cable. Refer to "Cable Adjustment" in the
adjustment
Maintenance section of this manual. If the auger does not stop
within 5 seconds, see authorized dealer for repair.
Discharge chute
See authorized dealer.
or deflector needs
lubrication.
Discharge chute or
Put snowthrower in heated garage or let unit run for a few minutes
deflector is frozen .
or clean off any snow and ice from the base of the chute.
Key is off or not installed. Turn key in to the ON position.
Primer not pressed.
Press primer button twice and start.
Frozen engine
Put snowthrower in heated garage to unfreeze engine.
Out of fuel.
Fill fuel tank.
Choke open - cold
Turn choke to closed, then press primer and start engine.
engine.
Engine flooded.
Turn choke to open; crank the engine repeatedly until it starts.
No spark.
Connect spark plug wire or replace spark plug.
Water in fuel, or old fuel.
Drain tank. (Dispose of fuel at an authorized hazardous waste
facility.) Fill with fresh fuel.
Cord not plugged in or
Plug in cord or replace defective cord; reset circuit breaker.
circuit breaker tripped
(Electric Start models).
Fuel mixture too rich.
Move choke to OPEN position.
Spark plug faulty, fouled,
Clean and re-gap spark plug or see authorized dealer.
or gapped incorrectly.
Fuel cap vent is blocked.
Clear vent.
Loose parts or damaged
Stop engine immediately. See authorized dealer.
auger.
Excessive snow left
See authorized dealer to determine if replacement scraper bar is
behind.
necessary.
Scraper bar worn.
See authorized dealer for replacement.
See authorized dealer for servicing the rubber auger.
damaged.
Auger drive belt loose or
Adjust auger control cable. Refer to "Cable Adjustment" in the
damaged.
Maintenance section of this manual.
See authorized dealer for belt replacement.
Discharge chute clogged
Stop engine immediately. Always use a clean-out tool to clear a
with snow.
clogged discharge chute, not your hands. Clean discharge chute
and inside of auger housing. Refer to "Warnings" in Operator
Safety section.
Foreign object lodged in
Stop engine immediately. Always use the clean-out tool to clear a
auger.
clogged chute, not your hands. Remove object from auger. Refer
to "Warnings" in Operator Safety section.
Rubber auger is worn or
See authorized dealer for replacement.
damaged.
Publicité
