Télécharger Imprimer la page

Oreck XL Edge Mode D'emploi page 8

Publicité

Les langues disponibles

Les langues disponibles

Maintenance
All manuals and user guides at all-guides.com
E
Unplug cord from electrical outlet before servicing.
Replacing the Odor Fighting HEPA Inner Bag
Inner Bag Removal
1. Unzip outer bag completely.
2. Pull plastic tab on bag dock to release bag dock from
connector. Bag dock door will hinge downward.
3. Gently pull bag cardboard collar upward out of the bag
®
dock. Saniseal
Inner Bag Installation
1. Slide the cardboard collar completely onto bag dock door.
2. Firmly push bag dock door with both thumbs on
indication point until it snaps.
Replacing the Brushroll
The brushroll is designed for long life.
Should it ever become worn or frayed, it can be
replaced by an Oreck Authorized Service Center.
Stuffing or Blockage
IMPORTANT: On plush and new carpets, stuffing may occur inside the intake tube and the lower tube
assembly. This is due to excessive fuzz and loose cuttings in the carpet. Stuffing could occur for the first
few cleanings until all the loose material is removed. Due to the high efficiency of the vacuum, many
older carpets will cause stuffing when the vacuum is first used on them. If your vacuum does not pick up
properly, or makes unusual noise, check for blockage, and clear if necessary in the following area's:
WARNING: Unplug cord from electrical outlet before servicing.
1. Clear any large obstruction or blockage from the vacuum.
2. Once the blockage is cleared, plug the vacuum back in and it will reset.
NOTE: If the vacuum continues to shut down, contact an Oreck Authorized Service Center.
Mouth Intake Blockage: If there is blockage
in the mouth intake, remove it with long-nose
pliers, screwdriver or coat hanger.
Bag dock door
Clear blockage
from this area
8
N
G
L
I
S
H
WARNING!
!
dust seal will close automatically.
Mouth of intake opening
Top Air Flow Blockage: Many times
blockage occurs due to a full inner bag
causing dirt to back down the air flow
system. When this occurs the blockage will be at the top
of the system, starting in the area where the inner bag
connects to the connector assembly. If the blockage is at
the top of the system, open the bag dock door, and using
long nose pliers you may be able to clear the area.
Bag dock
Cardboard
collar
Outer bag zipper

Publicité

loading