Oreck XL Edge Mode D'emploi page 7

Cleaning
Tips
7
All manuals and user guides at all-guides.com
E N
The XL Edge is the quietest and most powerful Oreck Upright. You'll love the way it cleans,
™
gets under things, and it's so light weight and easy to use. The following are a few simple sug-
gestions regarding its operation:
WARNING!: Do not use your vacuum on damp or wet surfaces. This will cause damage
to the vacuum and is dangerous to the user. Damage caused by use on wet or damp
surfaces is not covered under warranty.
1. When inserting a new disposable inner bag, first puff out
and OPEN the bag.
2. When the disposable inner bag is full, replace it.
3. Check the disposable inner bag at least once a month.
4. Do not run the vacuum over the cord. The revolving brushroll could damage the cord.
5. Use caution when vacuuming over area rug edges and fringe.
6. If at any time the machine does not pick up properly or makes an unusual noise, stop
operation and service.
7. Although your upright will pick up pins, paper clips, and other small objects, it is recom-
mended that these be removed from the floor before you vacuum. Failure to do so may
result in permanent damage to the motor suction fan and its housing.
8. At least once a month, check for and remove excessive lint, string or hair from revolving
brushroll. Wipe the outside of the vacuum with a damp cloth. Also clean the connector
deflector assembly area, base of vacuum and fan housing area. If there is dust in the outer
bag, vacuum it or shake it out.
Microban
®
Oreck added Microban
while manufacturing this Upright vacuum in order to inhibit the growth of bacteria in and on
the key touchpoints of the vacuum.
NOTICE: Wood Floors, Soft (Vinyl, Asphalt Tile, etc.)
Floor Surfaces and Polished Floor Finishes.
Use floor and floor finish manufacturer's recommended methods of cleaning. The brushroll
may also scuff very soft finishes. Keep the vacuum moving while in operation. A little
preventative maintenance will keep your vacuum looking new and will ensure continued
cleaning effectiveness.
Note: At least once a month, check for and remove excessive lint, string or hair from
revolving brush. Patented cleaning grooves on brush roll will allow easier cleaning. Wipe
the outside of the cleaner with a damp cloth. Also clean the connector deflector assembly
area, base of cleaner and fan housing area. If there is dust in the outer bag, vacuum it or
shake it out.
Microban ® is a registered trademark of Microban Products Company Corporation, North Carolina.
G L I S H
®
to the key touchpoints of the unit (handle, bag dock and baseplate)